1991 Chevy Camaro Z28 + EXTRAS!!!!!!! LOOK!!!!!!!!!!!

Description

Up for sale is my 1991 Chevy Camaro Z28
i am selling it as i do not have time to dedicate to this car with 4 kids and do not have garage space to store it properly. I have owned this car for the last 12+ years . I just washed car today from pictures shown and likely back to pollen tomorrow.
Mileage listed (234,933) is the odometer on car body, not engine or transmission. Engine was replaced (11/18/04-12/3/04) at mileage: 183,655 = 51,278Tranny replaced (1/18/11) at mileage: 229,970 miles = 4,963 miles
Car does have a 100 wet shot nitrous system setup but has never been programmed so never used.
** New Battery replaced in last 2 months** Will include all receipts that i have, which is A LOT
When i bought car it had these upgrades:

• ZZ4 crate motor
• Accel/Lingenfelter Performance Engineering (LPE) 58mm T-body
• LPE/Accel SuperRam Base Intake Manifold
• SLP Runners, port matched plenium
• 24lb/hr Ford SVO Fuel Injectors
• 4th Gen rear diff
• Energy Suspension, KYB's front and back
• Lakewood Lower Control Arms
• Walbro 255lph in tank fuel pump

Upgrades I have done to car:

• New Stock ECM Chip (Part #16151348) reprogrammed by FasterProms
• Replaced Throttle Body Return Springs
• 180 AMP Alternator with 4 gauge return wire
• Chevy logo oil breather
• IAC Motor (Part #25527077)
• IAC Plug Kit (Part #12085506)
• TPS Plug Kit (Part #12116257)
• Compucar 100shot wet Nitrous System
• NOS Remote Bottle Opener
• NOS Purge Kit with Duel Outlets in hood nose
• Accumulator Assembly (272-4700)
• power steering gear box : 12/2005
• Additional PermaCool Coolant Fan 7/2007

Car has a ZZ4 crate motor that was rebuilt with these parts on 11/18/04:

• CCA-7940-16 : Competition Cams Hi-Tech Pushrods
• CCA-850-16 : Competition Cams High Energy Hydraulic Roller Lifters
• CCA-613-16 : Competition Cams Super Valve Locks
• CCA-4800-8 : Competition Cams Pushrod Guideplates
• CCA-987-16 : Competition Cams Double Valve Springs
• CCA-730-16 : Competition Cams Titanium Valve Spring Retainers
• CRN-10750-16 : Crane Gold Race Extruded 1.5 Rocker Arm Kit
• CLO-9-3145 : Cloyes Original True Roller Timing Set
• ENS-3-1116R : Energy Suspension Engine Mounts
• ESP-5700BPLW : Eagle SIR I-Beam Connecting Rods
• MAN-11522-8 : Manley Race Series Stainless Steel Intake Valves
• MAN-11521-8 : Manley Race Series Stainless Steel Exhaust Valves
• MSD-8366 : MSD Pro-Billet Ready-To-Run EFI Distributor
• MSD-31249 : MSD 8.5mm Super Conductor Spark Plug Wires
• SLP-E-251K030: Sealed Power Chromemoly Piston Ring Set
• SUM-G6300W : Summit Cast Aluminum Timing Cover
• TRW-L2256F30 : Speed-Pro Power Forged Pistons

Exhaust:

Removed Emissions Tubes from headers, welded tops shut

Removed Smog Pump, replaced belt with larger one

QTEC 3" Electric Exhaust Cut Out

Flowmaster 80 Series 3inch in, 2.5inch duel out with Slanted Chrome Tips

Exterior:

Front and Rear wheel adapters

Alloy Technologies 18x8 5/15/12 ET40 Rims on 4/06

3.73 gears installed 6/04

Full Car cross-drilled slotted Zinc plated rotors by irotors.com

Pilot Navigator Fog Lights

Precision 3.73 High Carrier Gears

Ram Air Hood with functional K&N Ram Air system

H4 High & Low Beam Headlight replacements

Supra Style Spoiler with light

New Camaro Front Bumper Emblem (1408-3967)

New Parking Light Essemblies (5975682 (right) & 5975681 (left))

New Z28 Rear Bumper Emblem (1015-8545)

New 5.7 Tuned Port Injection Emblem (1006-6841)

New Z28 Side Rocker Emblems (1017-9122)

New PPG Toyota Jet Black Paint Job (12/2004)

Interior:

Blue/Green Indiglo Gauges

Autometer Phantom Nitrous Pressure Gauge

Nordskog Electric Air/Fuel Ratio Gauge

Older 3rd gen headliner light that has 2 reading lights

New Sun Visors

New Dimmer Switch (AC DELCO 199-5226)

Replaced Dash Pad

CB/PA System

Courtesy Light Dimmer System

Kenwood flip out deck with USB

Issues with car:

• IAC needs either cleaned or replaced for smooth idle rpm, drive rpm is not affected
• Oxidation from Florida sun - hood/roof/spoiler are hit bad with paint fade (my garage issue)
• A/C no longer works, appears compressor locked from sitting
• Trunk Motor needs replaced