Classiccarsexport.com

. "NO RESERVE"

  • Condition: Used
  • Make: Chevrolet
  • Model: Bel Air/150/210
  • Type: 4DR SEDAN
  • Year: 1956
  • Mileage: 109,927
  • VIN: B56S085490
  • Color: PRIMER
  • Engine size: 305
  • Number of cylinders: 8
  • Transmission: Automatic
  • Drive type: RWD
  • Interior color: TAN
  • Vehicle Title: Clear
  • Location: Bismarck, Arkansas, United States

Description

NO RESERVE!!!! Here's a Great, 1956 Chevy 4dr. sitting fully on 1981 Monte Carlo frame, suspension, floor pan, wiring harness and fuse block, seats, and tilt column.. 305 V8 4 brl carb. auto. trans . I never hooked up original heater, but is still there...needs wiper motor... Car has brand new front brake rotors, calibers, brake hoses, inner and outer wheel bearings.. Also has new front and rear springs and KYB shocks ..Has power steering as well. All 4 new tires !! This car runs straight, one finger will easily steer this car at 70 MPH on interstate. Rides like a 81 Monte Carlo, just has a 56 body. This Chevy as you can see in pics needs basiclly all new interior, your chose of colors It does have some rust under sill plates, that I don't have.Also do not have bumpers, nerf bars was what I was going to do.. I've sold a lot of my toys in the last year and have a few more that have to go before retiring this year. Ready to cruise right off the trailer. or you can drive it home . Remember NO RESERVE !! Thanks for looking, Please, if your looking for an economical toy, here it is !!!! Have title in hand, tagged in my name !! Has a new windshield and new seal as well... I'm getting a lot of questions on this car, thanks.. please look at the last 7 pics so you can see only the 56 shell was used. All of the floor originally mounted to frame .. the radiator, core support, engine, trans, drive shaft, rear end, the gas tank and all suspension is from the 81 Monte Carlo.including tilt column and seats. they cut along the edge and welded in from front to back including trunk, just look at spare tire mount. The only thing, they built a L shaped bracket to mount front end support. Hope this helps.. no popping noises,,