1976 chevrolet cheyenne stepside 4x4 restored

Description

This is a body-off restored truck that started out as a father/son project. My son lost interest so I finished it. All rust was cut out and new metal welded in.It has new:Heater Core, heater blower motor and restored heater boxL.E.D. 22" Strobe/spot light with remote control on front bumperCustom made Console
windshield glass and sealCB radio and Whip AntennaStereo and antenna and amp and speakersPower stationBodywork and PaintInner fendersTrans cooler and linesTransmission filter and panCarpet (black)undercoatingQuality aftermarket gauges custom installed in original dash bezel complete with turn signals and hazards and high/low beam lightWindshield Wiper motor and pumpPower steering pump120 amp 1-wire Alternator (chrome)Water pumpElectronic DistributorSending unitRebuilt 600 cfm Holley carbAluminum valve coversStainless steel headersExhaust/mufflersShocksRear Brakes and rear wheel cylindersMaster cylinderMuch more...
All metal has been sanded and rust treated. All deep rust cut-out and replaced with welded-in steelThe entire frame and suspension parts were cleaned and painted, no rustThe engine compartment was totally gone through and sanded/painted and all parts also, no rustBucket seats were hand picked for like new condition (adjustable)Custom made front and rear steel bumpers.Front bumper setup for WinchFront fender tire openings were pie-cut and moved forward for tire clearance at the front and looks excellent. Nobody noticed!L.E.D. tail lights. If you want stock ones they are easily available onlineThe motor is a fresh SBC 350 with an upgraded cam. You can hear/feel the cam...sounds good. The motor was rebuilt before I got it and only had 100 or 200 miles on it according to my neighbor who had it done.
Many hours went into this truck and was always indoors in my shopGlad to answer any questions about the truck
*NOTE: The tires are old and will need to be replaced by new owner.*NOTE: I forgot to get a new stabilizer shock. I will get a new one and install it before purchase.
The dual gas tanks were removed, cleaned, rust-treated and painted. All new fuel lines and filler/vent hoses. The tank straps were restored and one had to have a new bolt welded on.
The truck bed is bolted-on new 3/4" exterior plywood with undercoating on the underside. Can be changed or covered easily.
4" lift with 2" body lift = 6" lift.
The new windshield wiper water spray pump is not working (I installed a new one) and it might be something simple or could be a bad pump or the dash switch could be bad. The wipers work.
I just got done with this truck about 2 weeks ago. I am a body repairman. It took me about a year just for the body work//metal welded patch panels. It looks new and so does the inside motor compartment and the hood bottom and the cab. The paint is a single stage "Hammered" gun metal paint with automotive catalyst/reducer. The doors are 80's truck doors with their refreshed panels. The dash pad is an original crack-free. I installed a steel plate covering where the original speaker would have been with a steel bracket to mount a GPS monitor or?
*NOTE: The rear slider window was on the truck when I got it. One of the small lock clips is missing and the vertical felt seal.
Must pay in cash in person.
If you want a like-new rare short box step side chevy 4x4 truck rust free this is the one. The project took 4 years. I've built award winning street rods and am not a beginner at this. I'm not the best either but this is a very nice nostalgia truck and will probably increase in value.