1930 Chevy 3 Window Coupe

Description

1930 Chevy 3 Window Coupe Project. No time to finish it. Great project, tons of parts and great rust free body. Top chopped 2 1/2", Channeled 2 1/2". Suspension installed (Rolling Chassis), Body will need more metal finishing. Please don't bother with low ball offers. Trades possible. Call me to take a look, (951) 240-6550
-Tile in hand, registered with non-op, 1930 Chevy
-Frame Boxed and Cross-Braced, was in excellent original condition
- TCI independent front suspension with manual rack, disk brakes, coil-overs and sway bar
- TCI 4 link rear setup with coil-overs
- 8" Ford rear end
- 327 Chevy with Edelbrock Performer setup (dirty but good running motor)
(was removed from driving vehicle, was running well and prior owner indicated it had been rebuilt)
- 700R4 Trans (needs complete rebuild)
- New in box ET Wheels (Cost $1835.90)
--15X6" ET-GASSER, FULLY POLISHED, 4.5"B.C., 3 360.00 720.00 7/8"B.S. 2.00 W60FFP45
--16X10" ET-FUELER, POLISHED CENTER, 4.5"B.C., 460.00 920.00 3.5"B.S.
- Bear claw door latches
- Superior Glass Works rear trunk lid
- Nice original steel radiator shell (good one from truck, car ones were brass and are very fragile)
- Flaming River Steering Tilt Column (linkage compete to TCI steering rack)
- Stainless Steel Dietz-Style-Headlights
- TCI Brake booster and master cylinder
- BandM Street Rod Shiftier
- SpeedHut Guages ($650)
--4" Dual Gauge - 160mph GPS Speedometer / 8K Tachometer (w/ turn signal and high beam) / SKU: GR4-DUALGPS-ST-03T
--4" Quad Gauge - Water Temp, Volts, Oil psi, Fuel Level / SKU: GR4-QUAD-01
- Dress up parts for Engine, alum water pump, valve covers (all new in boxes)
Build yourself a Chevy Street Rod or a Rat Rod, lots of parts to get you going!Roller wheels and tires come with vehicle.
This Item is for sell local and can be canceled at any timePlease contact before purchase if you have a low history on e-bay