Classiccarsexport.com

1966 Corvette Convertible Project Car

  • Make: Chevrolet
  • Model: Corvette
  • SubModel: 2 door
  • Type: Convertible
  • Year: 1966
  • Mileage: 99999
  • VIN: 194676S11XXXX
  • Engine size: 396
  • Number of cylinders: 8
  • Fuel: Gasoline
  • Transmission: Manual
  • Drive type: RWD
  • Interior color: Black
  • Options: Convertible
  • Vehicle Title: Clean
  • Location: Harpursville, New York, United States

Description

Up For Auction Is My Last Convertible And It Is A Project Car.The rear body is basically stoc, the front clip is a GM clip that was customized back in the day . I do not know if is the original to the car or not. The body has beautiful caps at the door, deck li, and hood. The frame is rust free and do not see any in the birdcage either . The motor is complete 196, 396 Cubic Inch 359 HP and dated 1967 Casting Number 3902406 and from what i was told it is a Chevelle motor . There is writing on it that it needs some gasket, i would do your own checking before proceeding with starting it. It needs a complete wiring harness inside and out . The tranny is a Muncie 4 spee, case # 661 with 2 drain plugs . Do not know anything about it. The bellhousing is a 66 bellhousing #444 . The original colors are Maroon Exterior And Black Interior . The Interior is pretty complet, the carpet we received with it still in the box is new but the wrong color . The guy told me he had bought it years ago and never checked the color until we opened the bo, so he was stuck with that . You are welcome to have it with the ca, possibly dye it? All the interior Stainless is on the car and all the outside comes with the car as seen in pictures. It has rally wheels with all the trim and the factory hubcaps as well. Which will fit right on the rally wheels. It has Hooker Competition Headers And Side Pipes that are in very nice conditio, especially where you see them most on the outside . They also have non leg burners attached to themand the factory rocker molding have been trimmed to fit with the pipes .If the winning bidder does not want the motor and tranny set u, I will deduct $2,000 off the final outcome of the Auction. If you do not see it then sorry i do not have it . The windshield is new and tapped in for transport . It will need a gasket and molding clips before it can be installed . The soft top frame is beautiful condition but canvas is old ripped and needs to be removed . There are No Warranties Implied Or Other Wise Car Is Being Sold In As Is Condition .The Car Will Need To Be Trailered As It Does Not Run Or Have Brakes. I Will Help Load On My End No Problem. If you want to talk in person 607 seven Seven 59 Three seven 2 from 8:00AM to 9:00PM Eastern Standard Time No Other Calls Will Be Answered Or Returned Thanks! A $500 Non Refundable Deposit Is Due In 24 Hours Of Auction Ending Through Pay Pal And Balance Due In 7 Days Of Auction Ending Either Wire Transfe, Bank Check Or Cash If Picking The Car Up In Person And Must Clear Bank Before Releasing The Car Or The Paper Work No Exceptions Again No Pay Pal Except For Deposit And Of Coarse Shipping Is At The Buyers Expense ! Thanks For Looking

On Nov-04-19 at 04:35:28 PST, seller added the following information:

The Car in the last 5 pictures will be for sale as well . I will relist it after this 66 sells . These are my last two convertibles that i will be selling . Also typeo in HP it is a 396 Cubic Inch - 350 HP . It has the factory Cast Iron Holley Intak, not a Q-jet . Thanks !