1967 RS Camaro 327 automatic project car

Description

up for sale is a project I have not gotten time to work on in the last few years and not thinking I will in the near future so it is time for it to find a home that has time for it.
This is a rear RS 67 camaro.
Originally came with a 327. That was gone when I bought the car. It has a 1969 350 v-8 in the car.
There is no wiring harness in the car at this time but I have wired up the motor and installed a new edelbrock carb on it. It does run just fine and transmission goes into gear.
Body tub when I bought it had bad rust. I found another 67 body tub that had minimal rust and swapped it out. I have all the hidden vin areas ready to install along with the original cowl tag. I also have the original RS tail panel to install on this tub as well. I did not want to replace rust with Chinese replacement parts, I wanted to make sure it was put back with original GM metal.
Rust to deal with is as follows, Trunk pan, two spots on right rear quarter panel(have a good used section to fix it) and one small spot on the passenger front floor(have good patch panel to fix it as well)
It has very nice fenders along with new inner fenders. Nice core support.
It is a power steering and power brake car.
Does not have brake lines at this time. If needed for shipping I can make lines and install for a reasonable price.
As you can see from the pictures I have lots of parts for the car. Almost everything is there.
This is a real RS project car.
I have all paper work for the car.
This is not a rust bucket. it is a project that will be able to be finished with out a major headache on the buyers part.
Sold as is
Can stay here for 30 days for you to arrange shipping
I can take credit or debit car with square. I do not use pay pal.
if you need to buy with card there will be a 3% charge.
I want a $1000 deposit with in 3 days of sales end. Check, cash or card. No % charge on deposit payment.
Balance due with in 10 days of sales end.