1987 Chrysler Conquest/Mitsubishi Starion

Description

1987 Chrysler Conquest 83,xxx Miles

Runs great. AC has been removed because this was my track car. I only had it on track 4 times in the 3 years I've owned it but it was tons of fun. The power antenna and motor are missing because they were non-working and I never replaced them. Car is 100% rust free but the body has the typical look of a 30 year old car that's never been restored so don't expect perfection. There is an exhaust rattle at low RPM cruising around 40mph where the larger aftermarket exhaust hits the bell housing of the transmission. I'm sure this could easily be taken care of but I never cared enough to worry about it. I also have the tires that came with the car, when I bought it, which are in fair condition and will go with the car if you want them.

*****EDIT: I had mistakenly put a note below saying I had poly diff mounts that were not installed but came with it. That is not the case. That note was from an old local listing and those have been sold.*****

Performance parts installed are as follows:

• Short Throw Shifter
• Front 25mm, Rear 21mm Sway Bar Set
• Adjustable Strut Rods
• Front Camber Plates
• Rear Camber Plates
• MK1 Rear Struts
• MK1 Front Strut Cartridges
• Cosmo Coilover kit
• 88 ECU
• T3/T4 Turbo kit with hardpipes, blowoff valve, and ported/polished exhaust manifold (from Top End Performance)
• B-Pipe, Less Cat (2.5") (from Top End Performance)
• 2.5” Exhaust from B-pipe into Flowmaster 40 Series Muffler
• Autometer BoostGauge installed in the original location
• VDO Coolant Temp Gauge
• K&N Filter
• Stainless Brake Lines all 4 corners
• Grant GT Sport Steering Wheel
• BFG G-Force Rival 225/50-16 like brand new, less than 1000 miles, only 3 track days
• Griffin Aluminum Radiator & all new hoses
• SPEC Stage III Clutch + bearings
• Fidanza Flywheel
• Corbeau Forza Sport Seats (driver and passenger)
• Schroth Rallye 4 Harness (DOT) (driver and passanger seats)
• DM Intercooler
• Funk Lock Motor Mount
• Stedebani Poly Trans Mount
• Willwood big brake setup – Front