1968 Ford Bronco Coyote/6r80 Resto just completed

Description

1968 Ford Bronco Coyote/6r80 Build just finished this week by Addiction Motorsports. Test miles done and everything checked. Tiny interior details (powdercoat or leather cover the custom center console, and carpet kit, snap-in carpet pieces, or keep in coating) left so you can finish how you want.Body• No Rust and Super Straight• Paint is Porsche Silver Gray.• Hood Has functional custom mini scoop design for air circulation. Hood scoop was painted at a different time so needs some attention to match the quality of the body. Corner peel on edges of scoop only. Hood is good.• Interior has been Rhino lined and underbody also coated completely• Doors shut good and tight with good gaping• All door interiors are new including door latch, HD rods kit, glass tracks, door felt, anti-rattle kit• Door handles and side mirrors are new• Vent window assembly new• Complete body weatherstrip kit with doors, windshield, hardtop glass and liftgate all new Dennis Carpenter• Door window frame removable• Both inner fenders have been widened to accommodate the 5.0 Coyote. Removable and attached with stainless screws.• AMP Research power steps reinforcement plate installed. Ready for you to install the steps if wanted.Interior/Exterior• Hardtop interior has been Shield Dynamat then followed with a layer of ¼” Dynamat Foam layer then finished with an ABS shell headliner (not cheap cardboard). ABS shell is wrapped in Alcantara with added foam.• Both rear quarters have Shield Dynamat then ¼” Dynamat Foam also• Both door insides have the same with door panels also• Rear quarter panels custom made aluminum panels covered in leather.• Power windows installed with up and down functions using the window crank• ProCar Series seats completely redone. New powder coat for the frames, reinforced foam, and covered in black leather• Wild Horses Center Console in black leather also• Custom center console connected to dash ready to be powdercoated or covered in leather.• Interior door arm rest are wrapped in leather also• Speaker 8100 LED headlights• LED lights throughout• Double windshield wiper motors• Ididit Steering ColumnChassis/Suspension• Chassis was sandblasted and then painted.• Rebuilt Dana 44 with disk brakes and 4.10 gears• Rebuilt Ford 9 inch with disk brakes and 4.10 gears with 31 spline axles• All front and rear brake lines stainless flex. All brake hardlines Earls Stainless.• Wild Horses 1.5” lift kit with Bilstein 5100 shocks and HD Shackles new. HD spring cups• Front Anti Sway bar new• Custom Heim trac bar• Custom Bilstein steering stabilizer mount• Custom rear trac bar to handle the added Coyote power• BC Broncos HD radius Arms powder coated and new.• 2” Body lift with all new bushings• 17 x 7” custom wheels with 255/70/17 BF KO2 Powder coated black.• 4 point roll cage bolted to chassis.Motor/Drivetrain• 5.0 Coyote Motor Gen 1 (have engine cover if wanted)• Lokar 6R80 Floor shifter with Sport shift mode• 6R80 4x4 Transmission• Rebuilt Dana 20 with HD output shaft kit and custom T-Shift for the 6r80 mount• Power By The Hour Gen 1 control Package for motor and Transmission• Fat Fender Garage Gen 1 ECU cover and Mount• Painless 21 circuit wiring harness• Power By The Hour Transmission Coolant Kit and 6r80 fitting• BC Bronco Serpentine Coyote Kit• Ron Davis Aluminum Radiator for coyote with electric cooling fan• BC Bronco Ceramic coated headers and 2 into 1 coated exhaust with Borla muffler• MMR oil relocation kit• Wild Horses 23 gallon fuel tank with skid plate and custom mounting bracket• All fuel lines are Earls stainless with Redhorse braided stainless flex lines, AN fittings, and pressure regulator• Billet coyote starter• Hydratech hydroboost brake kit with stainless flex lines and Wilwood Master Cylinder• PSC Hydroboost Reservoir Black with remote filter mounted for easy change• Wild Horses Battery Holder with New Optima Battery