1979 f250 crew cab short box 4x4 partial restoration, finish stock

Description

Crew cab ford currently in primer at my body shop in central sd. Cab doors fenders and hood were taken to bare metal patched lower lh doors and one rh door sis body work with sheet metal pulled to 1/16 inch and did body work and glazed over and finished with 400 grit and then applied 3 coats of ppg vibrance dtm primer. Rear doors have one body line by handle that needs to be straighter. Fenders and hood same treatment for body work. Inside cab complete engine harness labeled chassis labeled short box is origional still needs box sides and tail gate rad support good motor ran wen we got it but alt was locked up. Did not drive it. Know the lock outs need gone through. Truck has clean title in hand and was a clean western sd truck. Customer paid $2500 for truck as is when we got it for him, he has had a bill of 13,000 for a year now and is unable to pay due to health issues so we are putting it up for sale to clear his bill. We ran the bill at 65/50/35/hr on three of us but with his 3,000 total down and starting out as low as we are to get it moved you are getting the job for around 40-hr. We will bolt cab and box on and hook up steering. We can finish the project for u as well how u want. We have a good 89 f350 4x4 in inventory for parts or a 93 roller with 5.13s on 37s. Or we can do about anything like a 5.9 swap etc. Check out Henriksen auto body on Facebook. 6056692059. This was the last project we did without $$ down as had done work with this guy fine in past but now we do run a reverse bill if u desire completion

We are going to go into this build after auction if doesn't sell, $14,000 additional finish chrome back on, turn key, new grille, front bumper bed liner seals, windows approximately, just scuff n shoot frame, and single stage body, paint cab as is, base clear, buff etc would be more $24,000 plus total

WE would hip shot a 12v diesel build for 7000, plus 2500 new clutch new nv4500 and adapter for 205, plus 3500 dana 60.70 and 12v 1991, with 170k, plus alternator and damper pulley, inc exhaust, motor would be untouched runs fine

37,000 plus total

higher end job figure a 50k truck

or you can buy as is.