1970 cutlass convertible

Description

1970 cutlass supreme convertible project car. Numbers matching 310h.p. rocket 350. I found a paryial huold sheet on top of the gas tank. Rebuilt carb. New sending unit. New floor pans, wheelhousings, full trunk pan and quarters. Doors were replaced with solid original ones. Car was a father son project and was being built to be a nice presentable driver, not a nut bolt restoration. Needs some minor body work, small dings here and there and the hood has a couple small rust holes on the front. The guy a bought it from'someone dad purchased a new white top with glass rear window, it will need installed. Interior has new carpet, the rest is original and shows some wear but definitely not shot. Ash tray door is broke. All lights seem to function properly although there is a few bulbs burnt out. With a little work you could drive the car as is for the summer and paint it over the winter. It has been parked in a garage since the early 90's so In order to do that I would replace the points (they're 30 plus years old) give it a basic tune up.Give it a good once over and check out the rubber brake lines, wheel bearings etc just to make sure it's safe. Car will nor leave until payment has cleared, I prefer cash on pick up, but if you are going to have it shipped I will need a bank check through a major bank like wells fargo. Sorry, no exception there is just to many scammers. Check my feedback. I have sold a proximately 15 cars on ebay. Thank you!

On Jun-19-16 at 18:12:42 PDT, seller added the following information:

I found a partial build sheet on top of the gas tank. The dad of the guy I bought the car from bought the new white top with glass back window.Sorry my phone was kind of doing its own thing when I was listing this.I could only get one picture up. I am working on getting more.

On Jun-20-16 at 16:24:20 PDT, seller added the following information:

Top is a power top, it goes up and down good. I installed new lines and switch.Transmission has a leak. I will try to see of it is coming from the pan or a seal and update when I can. The carb has been rebuilt but I think the float/ needle and seat may need some adjusting. If the car sets for awhile you have to crank it over for a bit or spray a little starting fluid in it and it starts right up and idles fine.