Classiccarsexport.com

1967 Chevrolet El Camino project vehicle with lots of new parts

  • Condition: Used
  • Make: Chevrolet
  • Model: El Camino
  • Type: El Camino
  • Year: 1967
  • VIN: 133807K115612
  • Engine size: none
  • Transmission: none
  • Vehicle Title: Clean
  • Location: Vandalia, Missouri, United States

Description

For sale 1967 Chevrolet El Camino project, no motor or trans. A lot of work has been done so far: 2" dropped spindles with disc brakes, new floor pans, new tailgate skin, new fenders, new cowl hood, new core support, new wheel wells, new below rear window panel, new below front windshield panels already installed, Hagan gas door has been installed in the bed, rear tail lights have been frenched in flush with the quarter panels, drip rails have been eliminated and reshaped, new wider wheel tubs in the bed, front suspension is set up for power rack and pinion have new mustang II rack, front lower control arms have been boxed, quarter panels have been pulled off and patched, firewall has been smoothed, custom transmission tunnel, custom dash. Have over $10,000 of new parts see list below and many extra original and donor parts that go. Have many pictures of the work as it progressed and receipts of parts purchased.
This will be a great winter project to finish, just don't have the time to do get to it anymore. Has been sitting for a few years so some of the parts have surface rust.
List of new parts that are included:
ORIGINAL PARTS GROUP:
2" steel cowl induction hood, left & right front fenders
Rear window chrome mouling set
LED rear tail light conversion kit
Bed side chrome moulding kit
SS grill kit
Body bushing kit

Rear sway bar kit
Door striker & washers
Front valence panel
Front edge dash kit (sheetmetal repair installed)
Radiator support
Inner fenders left & right
Inner fender hardware kit
Front sway bar kit
A-arm ball joints, bolts & bushings
Headlamp adj. spring kit
Tailgate skin (installed)
Ext. chrome door handle kit
Fuel tank
Fuel tank straps & seals
Door hinge repair kit (installed)
Rear window patch panel (installed)
Weatherstrip kit
Window felts
Front bumper
Tailight lenses
Left & right door latch assembly (installed)
IDIDIT chrome tilt steefing column (installed)
OLD DOG STREET RODS:
Hagan gas door (installed)
Vision side mirrors
Mustang II power rack
Steering column shafts and bushings Stainless Steel

YEAR ONE:
Left quarter panel skin (installed)
Fuel sending unit
Body shims
THE PADDOCK:
Full LH & RH floor pans (installed)
ANDRE'S EL-CHEVELLE INC.:
Left & Right doors
Trans. Cross member
Bumper brackets
Lower control arm
PERFORMANCE ONLINE:
Front disc brake conv. Kit
TOTALLY STAINLESS:
Complete Stainless Steel body bolt kit
YOGI'S INC.:
Painless 18 circuit wiring harness kit
3 switch kit: lights, ignition & wiper
AHRENS STEEL:
sheet metal for car (installed) trans tunnel, firewall, rear wheel tubs, etc.
SUMMIT:
QA1 rear coli overs
QA1 front coil over spring kit
Trottle pedal Lokar
Coil over spanner wrench
Headman Headers ball flange kit
Hooker shorty headers for small block
Edelbrock rear adj. upper trailing arms
Autometer Phantom 2-5/8" fuel guage
" " " volt guage
" " " water temp. guage
" " " oil pressure guage
" " 3-5/8 tack. guage
" " 3-5/8 speedometer guage
Edelbrock lower boxed trailing arms
Autometer speedometer sender
8" Lokar trans. Shifter
Dash wiring harnes for guages
Billet Specialties Torq Thrust steering wheel: black leater wrap & bowtie horn
Trottle cable Lokar