1993 Ford Mustang, 331, Single Turbo, Tremec 3550

Description

60 photos of the car can be found by Clickinghere
1993 Coupe. Stock block 331 62-1 turbo. 5 speed. Factory white with black interior. If you have been looking for a clean white coupe with black interior this is the one. Interior is super clean. The doors are tight. Car is straight. Its has been repainted at some point before I took ownership. The paint job is very good. Moldings are painted. The car has a few chips here and there but overall I'd rate it a solid 8. I added a 3 inch cowl HO Fiber trend. It needs painting. Arm rest is new. The inner door handle pads are new. Engine bay was smoothed. Wiring is tucked. Car has a lot of new parts on it. Had it tuned it on the street using Moates quarter horse. No dyno numbers. I didn’t build it to be a track car just a fun street car. Only issues I can think of are…the speedometer doesn't work. I put a new gear and sending unit in still nothing. It needs an alignment.
I have an extra set of back tires and a new spare piston to go with the car as well.

Engine
Stock block DSS 331. H beam rods, Cp pistons forged crank
Arp head Studs
Cometic Gaskets
FMS z303 cam
FMS 1.6 rockers
GT40 Aluminum heads. Fresh from machine shop. Hand port job, New valves, springs, retainers, decked.
SFI balancer
Msd 6al in fender well
MSD coil
MSD dizzy.
New Alternator
New Starter
Electric fan
Aluminum radiator
Edelbrock performer rpm, hand ported to heads.
7qt oil pan
Turbonetics 62-1
All stainless hot side. This is NOT Chinese junk
3inch stainless DP,y off to 2.5 dynomax muflers. 2.5 tailpipes

Fuel
New 310 intank pump
Modified fuel hat has -6 fittings
New 42# inj
-6 supply -6 return
Weldon regulator
Cartech fuel rails

Tranny
New Tremec 3550 has 26 slpine input and large output.
New Ram clutch
New Flywheel
FMS Aluminum Driveshaft
03 04 cobra shift knob

Suspension/brakes
New FMS 13inch cobra brake kit. master cylinder/ rotors/ calipers/ rear axles etc. coverts car to 5 lug.
New Grantelli K member
New Grantelli coil overs
New Grantelli CC plates
94-95 spindles
Bump steer kit
Long studs front and back.
3.55 gear.
Girdle
Bolt on Sub frame connectors
Adjustable uppers and lower control arms
Real 04 cobra wheels/ center caps are not but back of wheel proves it
New BFG front tires
2 sets of BFG for the rear

Interior
Factory blk doors, seats, carpet, etc.
Autometer tach
Autometer boost, tranny temp which is not hooked up
Optima battery in the trunk.

Any questions call or txt me.
Also I appreciate offers but be realistic I will part it out and get more than I'm asking easily.
2522670421 thanks for looking